I recently installed a Cudy POE150 30 watt injector and a POE15 Extender. I am using them with an approximate 525 run of Ubiquiti Carrier Class Outdoor CAT5e Tough Cable. Everything is AF/AT compatible (at least it's supposed to be)
My configuration is as follows:
POE150 > 100m Ubiquiti Carrier Class Outdoor Cat5e > POE15 > 76m Ubiquiti Carrier Class Outdoor Cat5e > Ubiquiti INS-8023AF-O Power Converter > Ubiquiti Powerbeam PBE400.
The PBE400 powers up fine and connects (with a good signal) to the remote point HOWEVER I am unable to get data flow from (or to) the PBE400 via the LAN connection over the entire cable run.
If I temporarily replace the Extender with the Injector (and use the 76m run), I can connect to the PBE400 via the LAN. If I move the PBE400/INS-8023AF-O to the end of the 100m run, I can likewise connect to the PBE400 via the LAN. But if I try the entire 525 ft run, no go
My configuration is as follows:
POE150 > 100m Ubiquiti Carrier Class Outdoor Cat5e > POE15 > 76m Ubiquiti Carrier Class Outdoor Cat5e > Ubiquiti INS-8023AF-O Power Converter > Ubiquiti Powerbeam PBE400.
The PBE400 powers up fine and connects (with a good signal) to the remote point HOWEVER I am unable to get data flow from (or to) the PBE400 via the LAN connection over the entire cable run.
If I temporarily replace the Extender with the Injector (and use the 76m run), I can connect to the PBE400 via the LAN. If I move the PBE400/INS-8023AF-O to the end of the 100m run, I can likewise connect to the PBE400 via the LAN. But if I try the entire 525 ft run, no go