configure router as a load balancer

Started by kashman, March 28, 2022, 12:49:52 AM

Previous topic - Next topic
Print
Go Down Pages1
User actions

kashman

March 28, 2022, 12:49:52 AM
I want to configure hEX lite RB750r2 as a load balancer. I connected my 2 modems to port Internet and Lan 1. DHCP is enabled in both modems and they are using different IP ranges (192.168.1.0/24 & 192.168.2.0/24)
I added DHCP client for ether 1 (Internet Port) and it successfully obtained new IP address from modem 1.
But when In try to do the same procedure for the 2nd modem which is connected to ether 2(Lan 1), It can not obtain new IP addresss.
If I connect modem 2 to router's internet Port it can obtain new ip address successfully.
How can I fix this?

deanwebb

#1
April 02, 2022, 08:45:30 AM
How are the DHCP scopes configured? Other than the address range, is there anything different between the two?
Take a baseball bat and trash all the routers, shout out "IT'S A NETWORK PROBLEM NOW, SUCKERS!" and then peel out of the parking lot in your Ferrari.
"The world could perish if people only worked on things that were easy to handle." -- Vladimir Savchenko
Вопросы есть? Вопросов нет! | BCEB: Belkin Certified Expert Baffler | "Plan B is Plan A with an element of panic." -- John Clarke
Accounting is architecture, remember that!
Air gaps are high-latency Internet connections.
Print
Go Up Pages1
User actions