TACLANE SNMP Question

[config t]

Currently exploring whether I can pull information from a TACLANE with SNMP. Closest bit of info I can find is a 6-year old solarwinds forum post.

Knowing all TACLANE are a little different.. do they have the capability to host SNMP creds?

*edit*

For context, I am looking to pull this info into NAC using supplied SNMP creds on the device.

[Otanx]

Yes you can. On the KG configure your SNMP server as a GEM server. It only does SNMPv3. I don't remember for sure but I think it was using AES128/SHA for protocols. Also the MIBS can be found on one of the CDs either the KG firmware one or the GEM install one.

-Otanx

[deanwebb]

Yes you can. On the KG configure your SNMP server as a GEM server. It only does SNMPv3. I don't remember for sure but I think it was using AES128/SHA for protocols. Also the MIBS can be found on one of the CDs either the KG firmware one or the GEM install one.

-Otanx

I feel a swell of pride as I understand every. single. term. used in this response.

[config t]

Yes you can. On the KG configure your SNMP server as a GEM server. It only does SNMPv3. I don't remember for sure but I think it was using AES128/SHA for protocols. Also the MIBS can be found on one of the CDs either the KG firmware one or the GEM install one.

-Otanx

Can confirm in documentation it is AES128/SHA. No luck yet, but I've only been able to try polling the CT interface so far. Tomorrow I will ask my buddy to give it a shot from NAC on the PT side and see what happens. Unfortunately it's not my gear, so I have to be mindful about my demands 

Can you expand on the MIBS? All I've tried so far is a generic sysinfo poll but I do have an option to define OIDs under a different type of policy condition.

I feel a swell of pride as I understand every. single. term. used in this response.

It's true we have basically learned a second language